Error when using "teve 1.2.7" by eBersa

[mopar]

Hi,

I have downloaded and installed a tcl from this site that is suposed to read the swedish TV guide at www.tv.nu
I have installed the tcl and just made a few small changes to the settings, as in if the output should be sent to the channel or the user and such.

Now when i do the command !teve or !tv <channel> or such I get this error on the bot;
<Bertone> [19:44] -- Teve triggat av m0par på #wtcc : !teve
<Bertone> [19:44] TCL error [teve:greppap]: can't read "teve(tv1ka)": no such variable

As I am a total n00b when it comes to tcl's I don't know where to start looking, I'm not sure if this rather short information is enough for you guys to get an idea of what might be wrong but all help would be apreciated.

Thank you in advance
mopar

[Sir_Fz]

We'll not search for the script and check it for errors, you'll have to paste the code. But first, try contacting the script's author before resorting to this forum. Also, read the "help us help you" topic in the scripting help forum.

[mopar]

I did leave a msg to him, but I don't know if he logs on here anymore.
I will read the suggested thread and see what i can make out of it.

I'd be glad to paste the code, but as I can't figure out where the code goes wrong I don't know what part of the code to paste so far. Pasting the entire code seemed like a less good idea to start with.

I apreciate the help anyhow.
/mopar

[Alchera]

I did leave a msg to him, but I don't know if he logs on here anymore.

Sending him an e-mail (b34r@linuxmail.org) would not be too difficult.

[mopar]

Cheers mate, I think I can manage that.

/mopar

[b34r]

I't been a while, but here goes:
v2.0 released
get it at http://b34r.ath.cx/misc/teve/
Hopefully it will work

[mopar]

Well I have downloaded the new version, and spoke online with the author, and it now works as a charm. (If you are swede that is:)

Thanks for the help!

/mopar