pushmode only works for 1 mode

Post by **Sir_Fz** » Mon Jul 28, 2003 6:01 pm

I usually like to use pushmode for removing modes rather than * "MODE.."
but if i use pushmode $chan +mR for example it only sets +m, so is there to make it set any modes with pushmode ?

Post by **user** » Mon Jul 28, 2003 6:38 pm

pushmode twice

Post by **Sir_Fz** » Mon Jul 28, 2003 6:57 pm

well i have set modes
like for example set modes "mR"
[snip]
pushmode $chan -$::modes (only sets mode -m)

isn't there a way for it or should I use putserv..

strikelight · Post by **strikelight** » Mon Jul 28, 2003 8:14 pm

pushmode is for queueing a single mode at a time...
(read tcl-commands.doc)

Upon completion of a procedure, the pushmode queue will be emptied...
Thus.. all you need to do, as stated, is use multiple pushmode statements..

ppslim · Post by **ppslim** » Tue Jul 29, 2003 5:06 am

Asnoted in the last post.

At the end of the procedure, and however many pushmodes, eggdrop will reconsturct them down to as simpler form as possible. ie, the -mR that you wanted.

Post by **Sir_Fz** » Tue Jul 29, 2003 5:29 am

yes ur right, the pushmode tries to simplify all modes in once mode change, ok thanx I'll add multiple pushmode lines