Setting up Bot in shell

Penguin · Post by **Penguin** » Fri Sep 06, 2002 9:09 am

Hi, I'm new to using eggbots, so i came here.
I have a sheel with freebsd.titanix.d2g.com they have the bot installed, but i don't know how to configure it, n e ideas would b welcome, thanx.

brusher · Post by **brusher** » Fri Sep 06, 2002 4:35 pm

http://www.egghelp.org/setup.htm

Penguin · Post by **Penguin** » Sun Sep 08, 2002 4:19 am

Thanx, but i've read that, unfortunately, i didn't "install" the bot as it were, the shell had the bot, and all i did was type the command install bot, and it was installed onto my shell, however i do not know where the files are located

I have to use putty 6 to connect using ssh as this is what the operator person said i have to do, ne moe ideas/suggestions?

ppslim · Post by **ppslim** » Mon Sep 09, 2002 5:48 am

Contact the shell support section.

If they provide commands, they should support them.

[bot-build] · Post by **[bot-build]** » Tue Dec 07, 2004 10:54 pm

Penguin, titanix is by far the worste shell i have ever seeni know from personal experiance my suggestion is actually paying for a shell but if you insist on running it after you install bot do the following

cd /eggdrop
pico eggdrop.conf

after you finished the conf file, hold ctrl and press x this will ask you if you want to save changes type y and then press enter

after this type eggdrop -m eggdrop.conf

* note with titanix you dont need the ./ infront of the command

demond · Post by **demond** » Wed Dec 08, 2004 12:20 am

your help is a little bit late buddy... 2 YEARS LATE!

Alchera · Post by **Alchera** » Wed Dec 08, 2004 9:52 am

Seems to be a new disease. LOL I just found another one in another thread.

[bot-build] · Post by **[bot-build]** » Wed Dec 08, 2004 5:59 pm

haha yea, never know other ppl may look for the same info, so i posted it for future reference