ports 4 eggdrop

gRiMMi · Post by **gRiMMi** » Tue Jan 08, 2002 8:33 am

Hi
i need all ports which eggdrop use ... thx
or anyone know how to config a Bintec X3200 Router for eggdrop?

thx

Petersen · Post by **Petersen** » Tue Jan 08, 2002 4:26 pm

1024 through to 65536 as default. Anything you configure it to use otherwise.

gRiMMi · Post by **gRiMMi** » Wed Jan 09, 2002 1:35 pm

if port 1024 is open
its enouth?

gRiMMi · Post by **gRiMMi** » Wed Jan 09, 2002 1:38 pm

its tcp or?

need any udp port?

and which ports do i need for DCC ?

thx

Petersen · Post by **Petersen** » Wed Jan 09, 2002 5:34 pm

tcp

and as i said 1024 through to 65536 as default for dcc listen ports (randomly assigned by the operating system from the open port pool).
as i said, this can be changed to whatever portrange you like (via $reserved-portrange). Note that explicitally defined listen ports can fall outside this range, but this again is down to your configuration.

guppy · Post by **guppy** » Wed Jan 09, 2002 6:57 pm

and as i said 1024 through to 65536 as default for dcc listen ports (randomly assigned by the operating system from the open port pool).

65535 actually.

Petersen · Post by **Petersen** » Wed Jan 09, 2002 8:06 pm

yah, my bad. you'd think by now i should know the maximum for a 16-bit integer, heh. guess i shouldnt answer questions when i'm tired