error command no server

[hype]

hey, I put in the right ip on to the config and i get this:

Eggdrop v1.6.18 (C) 1997 Robey Pointer (C) 2006 Eggheads
[00:56] --- Loading eggdrop v1.6.18 (Thu Sep 28 2006)
[00:56] Listening at telnet port 5395 (all).
[00:56] Module loaded: dns
[00:56] Module loaded: channels
[00:56] Module loaded: server
[00:56] Module loaded: ctcp
[00:56] Module loaded: irc
[00:56] Module loaded: transfer (with lang support)
[00:56] Module loaded: share
[00:56] Module loaded: console (with lang support)
[00:56] Module loaded: blowfish
[00:56] Module loaded: uptime
[00:56] *** shoutcast.tcl v1.03 by domsen <domsen@domsen.org> succesfully loaded. turn it up baby.
[00:56] Userinfo TCL v1.07 loaded (URL BF GF IRL EMAIL DOB PHONE ICQ).
[00:56] use '.help userinfo' for commands.
[00:56] * NO SERVER.

# This is the bot's server list. The bot will start at the first server listed,
# and cycle through them whenever it gets disconnected. You need to change these
# servers to YOUR network's servers.
#
# The format is:
# server[:port[:password]]
#
# Both the port and password fields are optional; however, if you want to set a
# password you must also set a port. If a port isn't specified it will default to
# your default-port setting. { gamesurge.burstfire.net:6667 }

this is an ipv6 server
http://tehh4x.org/IPv6

[DragnLord]

your conf file section should look like this:

Code: Select all

set servers { gamesurge.burstfire.net:6667 } 

[De Kus]

I doubt his eggdrop even supports IPv6.

[Azeem]

While editing the conf please keep in mind the difference between
a comment and a un-comment line

for e.g.

Code: Select all

# set abc "123" 

in this case abce is not being set because of the # the line after # wouldnt be read

so u should uncomment all the lines that are required for an eggdrop to run
successfully..


Regards
Azeem

[Alchera]

Setting up an Eggdrop

Try reading it properly.