Question!!!

Frk · Post by **Frk** » Wed May 29, 2002 12:38 pm

i have compiled the simple.conf for my Eggie.
what i wanna know is how can i make my Eggie use a Vhost?

can ne1 tell me step by step please

. i have Vhosts and Everything. i just need to know what's the line or comand should i do to do it?

Thanx all

DrTongue · Post by **DrTongue** » Wed May 29, 2002 7:10 pm

Towards the top of the config file you will find the following:

set my-hostname "your.funny.vhost.here"
set my-ip "number that goes with IP here"
(i.e. set my-ip "xx.xx.xxx.xxx")

With most shell accounts, IN the shell you can type the command "vhosts" and it will lists all the vhosts available on that shell and the co-ordinating IP numbers.

<font size=-1>[ This Message was edited by: DrTongue on 2002-05-29 17:12 ]</font>

Frk · Post by **Frk** » Wed May 29, 2002 8:35 pm

Thanx 4 Replying...

but in the simple.conf file i can't see those lines. i can only see them in the advanced and the complete conf's files. and i don't want to use advance nor complete. i'm just new to this.

so what shall i do now?

craze · Post by **craze** » Wed May 29, 2002 8:42 pm

Write/copy the lines into the config

Frk · Post by **Frk** » Wed May 29, 2002 8:46 pm

ok should i copy/paste the lines in any place? or should i do it in a certain place in the con file?

DrTongue · Post by **DrTongue** » Wed May 29, 2002 10:31 pm

Have always used the complete.config here so I'm not familiar with simple.config. In the complete.config it is under
***General Stuff*** section.

Frk · Post by **Frk** » Wed May 29, 2002 10:34 pm

it's okay now..... i have managed it. and eggie is running..

Thanx goes to you man. Thanx alot.. but can you tell me one thing. before i did run the egg. i placed the .tcl files in the scripts DIR. then added their sources to the .conf file. when i start the bot now...will the scripts work? or should i rehash the eggie?