All of the Commands only for +v and above users.

Viperb0y · Post by **Viperb0y** » Wed Aug 06, 2008 9:19 am

Hi,

currently I'm using this script on my Eggdrop:

http://paste.tclhelp.net/?id=kv

I use the +f flag to see if the Users are allowed to to the !smut things etc. But I don't want to add every user to the userlist.. too much work

.

Is there a way to only allow the commands to +v and above users?

Post by **Sir_Fz** » Wed Aug 06, 2008 2:34 pm

You can add a check for +v in each proc (and remove the flags from the binds).

Code: Select all

if {[isvoice $nick $chan]} {
# $nick has +v on $chan
}

Viperb0y · Post by **Viperb0y** » Wed Aug 06, 2008 5:36 pm

Hi,

so i have to put your code in every proc? Hm.. okay but a lot of work

P.S. If a user has +o.. is he includen in "isvoice"?

Alchera · Post by **Alchera** » Wed Aug 06, 2008 9:18 pm

Viperb0y wrote:P.S. If a user has +o.. is he includen in "isvoice"?

Obviously not.

isop <nickname> [channel]
Returns: 1 if someone by the specified nickname is on the channel (or
any channel if no channel name is specified) and has ops; 0 otherwise
Module: irc

Viperb0y · Post by **Viperb0y** » Thu Aug 07, 2008 7:12 am

Hi,

okay.. but another Problem.

The network also has Users with a % and ! prefix.. what is with them? I also want them to use the bot.

Post by **nml375** » Thu Aug 07, 2008 12:04 pm

See the opchars config-setting in newer eggies:

eggdrop.conf wrote:# Some IRC servers are using some non-standard op-like channel prefixes/modes.
# Define them here so the bot can recognize them. Just "@" should be fine for
# most networks. Un-comment the second line for some UnrealIRCds.

set opchars "@"
#set opchars "@&~"